@

Friday, March 16, 2012

How To Replace Evaporator Core Orifice On Ford Ranger?

The Evaporator Core Orifice replacing for ford Ranger is as follows:---

Evaporator Core Orifice Removal & Installation Procedure is mentioned below:----


  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Recover the refrigerant.
  3. Disconnect the condenser-to-evaporator line fitting at the evaporator inlet tube. Discard the O-ring seals.
  4. Inspect the evaporator core orifice for damage before attempting to remove it from the evaporator core inlet line. 

    image
    Fig. Evaporator core orifice tube
  5. If the evaporator core orifice is intact, engage the Fixed Orifice Remover/Installer. Hold the T-handle stationary while rotating the tool body to remove the evaporator core orifice
  6. If the evaporator core orifice is broken, screw the end of the Broken Orifice Remover into the broken orifice. Hold the T-handle stationary while rotating the tool body to remove the evaporator core orifice. 

    image
    Fig. Using the orifice tube remover/installer, remove the orifice tube
To install:
  1. Lubricate the evaporator core orifice O-ring seals with clean PAG oil and install the evaporator core orifice using the Fixed Orifice Remover/Installer. 

    image
    Fig. Using the orifice tube remover/installer, install the orifice tube
  2. Install new O-ring seals and connect the condenser-to-evaporator line fitting at the evaporator inlet tube
  3. Evacuate, leak test and charge the refrigerant system. R-134a Refrigerant Fill Capacity: 2.07 lbs.


These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment