Transfer Case Replacing on Toyota Sequoia and Land Cruiser?

The details mentioned below are similar for both Toyota Land Cruiser and Sequoia car models.

Transfer Case Removal & Installation Step by Step details with diagrams are as follows :----

1. Before servicing the vehicle, refer to the Precautions section.
2. Drain the transfer case oil.
3. Place the shift lever in the H position and the one-touch 2-4 switch OFF.
4. Remove or disconnect the following:
   
   
   Shift lever

   Skid plate

   Oil from the transfer case

   Exhaust pipes

   Front and rear driveshafts

   Crossmember

   Rear engine mount

   All wiring connectors
5. Support the transfer case, remove the case-to-adapter bolts and lower the transfer case.
6. Installation is the reverse of removal. Note the following torques:
   
   
   Transfer case-to-adapter bolts: 17 ft. lbs. (24Nm)

   Engine rear mount-to-adapter: 48 ft. lbs. (65Nm)

   Crossmember: 53 ft. lbs. (72Nm)

   Engine rear mount set bolts: 13 ft. lbs. (18Nm)

   Skid plate: 13 ft. lbs. (18Nm)

see the Helping diagram as follows:---
Transfer case and related parts-Sequoia

1. Before servicing the vehicle, refer to the Precautions section.
2. Drain the transfer case oil.
3. Remove or disconnect the following:
   
   
   Transfer case protector

   Front and rear driveshafts

   Transfer case shift lever rod

   Ground cable

   Transmission mount crossmember. Support the transmission with a jack.

   Transfer case vent hose

   Vehicle Speed (VSS) sensor connector

   Center differential lock indicator switch connector

   Motor actuator connectors

   Transfer case adapter bolts

   Transfer case

To install:

1. Install or connect the following:
   
   
   Transfer case. Tighten the adapter bolts to 51 ft. lbs. (69 Nm).

   Motor actuator connectors

   Center differential lock indicator switch connector

   VSS sensor connector

   Transfer case vent hose

   Transmission mount crossmember. Tighten the bolts to 37 ft. lbs. (50 Nm) and the nuts to 54 ft. lbs. (74 Nm).

   Ground cable

   Transfer case shift lever rod

   Front driveshaft. Tighten the fasteners to 59 ft. lbs. (80 Nm).

   Rear driveshaft. Tighten the fasteners to 78 ft. lbs. (106 Nm).

   Transfer case protector
2. Fill the transfer case to the correct level.

See the Land cruiser help diagram as follows :----
Transfer case and related parts-Land Cruiser:--

 

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html